Dynomotion

Group: DynoMotion Message: 15355 From: kn6za Date: 2/7/2018
Subject: bug report with G95/G94

Tom,


  In 434i the feed rate over ride works in G95 IPR mode, but only with FRO values larger than 1. FRO values less than 1 are ignored.



   Andrew
Group: DynoMotion Message: 15356 From: Tom Kerekes Date: 2/7/2018
Subject: Re: bug report with G95/G94
Hi Andrew,

KFLOP doesn't support hardware FRO in G95 IPR mode.

Do you find FRO in G95 IPR mode useful?

You might force all Software FRO by setting Hardware Range to 0.  See:
http://dynomotion.com/Help/KMotionCNC/ToolSetupScreenTP.htm#Feed_Rate_Override

Regards
TK



On 2/7/2018 2:19 PM, kn6za@... [DynoMotion] wrote:
 

Tom,


  In 434i the feed rate over ride works in G95 IPR mode, but only with FRO values larger than 1. FRO values less than 1 are ignored.



   Andrew
Group: DynoMotion Message: 15357 From: andrew abken Date: 2/7/2018
Subject: Re: bug report with G95/G94
Yes, FRO in IPR mode is very helpfull as there are times when you are trying to dial in feed rate that breaks the chip best.

Once I find the right feed for the cut, I then change the program to that IPR and run without FRO.

Interesting that g94 feed moves are not affected in the same manner.

I will try setting hardware range to 0, I don't see any reason that won't work.

Thanks!

Andrew Abken
On Feb 7, 2018, at 5:53 PM, "Tom Kerekes tk@... [DynoMotion]" <DynoMotion@yahoogroups.com> wrote:
 

Hi Andrew,

KFLOP doesn't support hardware FRO in G95 IPR mode.

Do you find FRO in G95 IPR mode useful?

You might force all Software FRO by setting Hardware Range to 0.  See:
http://dynomotion.com/Help/KMotionCNC/ToolSetupScreenTP.htm#Feed_Rate_Override

Regards
TK



On 2/7/2018 2:19 PM, kn6za@... [DynoMotion] wrote:
 

Tom,


  In 434i the feed rate over ride works in G95 IPR mode, but only with FRO values larger than 1. FRO values less than 1 are ignored.



   Andrew